bm

Body mounting.

There are many ways to mount your hard body to a drag racing chassis, these are some of them,
I'm sure there are a lot more of them out there. Please feel free to contribute your ideas.
One thing you must understand that you need some play on the body to rear of car, otherwise
your body will crack, so the tubing at the back should somehow float.

b500

Most standard way to pin your car.

These two examples are used for in front of the front wheels.
Brass or stainless tubing can be sued for these applications.

b500

This is to hide rear pins on the exterior of the car body.

b500

Solder the brass tubing to the chassis, the tubing will float that way.

b500

On some chassis you will need to notch a opening so your
tubing can go through.
b500

Another view.

b500

Tubing for slots on the chassis.

b500

How to hide the front pins.

b500

The picture will have to go through the yellow hole before you
be able to slide it into the brass tubing. This is hard to deal
with, because you will need needle nose pliers to remove
and install the pins.

If any one wants to contribute, please send in your picture and instructions.